Safety Precautions - Before You Begin - hestan KDO Use And Care Manual

SAFETY PRECAUTIONS - BEFORE YOU BEGIN

ELECTRICAL SUPPLY
This appliance must be connected to a dedicated circuit, 240 VAC or 208 VAC, Single Phase, 60
Hz, with a current rating as shown in the model number listing on page 6.
EN
Have the installer show you where the electric circuit breaker is located so you know how to
shut off the power to this appliance.
It is the responsibility of the user to have the appliance connected by a licensed electrician
in accordance with all local codes, or in the absence of local codes, in accordance with the
National Electrical Code. Read the ELECTRICAL CONNECTIONS section of the Installation
Manual for complete details.
GENERAL APPLIANCE AND OVEN SAFETY PRECAUTIONS
Please read all instructions before using this appliance.
When properly cared for, your new oven has been designed to be a safe, reliable appliance.
Read all instructions carefully before using this oven. These precautions will reduce the risk of
burns, electric shock, fire, and injury to persons. When using kitchen appliances, basic safety
precautions must be followed, including the following:
TECHNICAL SAFETY
Installation and service on this appliance must be performed by a qualified appliance installer,
or a Hestan service technician. Do not repair or replace any part of the appliance unless
specifically instructed to do so. Defective parts must only be replaced with genuine Hestan
parts. Contact Hestan Customer Service for inquiries or to arrange a service call.
This appliance must be properly installed and grounded by a qualified technician. Read the
ELECTRICAL CONNECTIONS section of the Installation Manual for complete details.
Locate and install this appliance only in accordance with the Installation Instructions.
Do not operate this appliance if it is not working properly or if it has been damaged, until an
authorized servicer has examined it.
Use this oven only as intended by the manufacturer. If you have any questions, contact the
dealer or Hestan Customer Service.
Use this appliance only for its intended use as described in this manual. Do not use corrosive
chemicals, vapors, or nonfood products in this appliance. This type of oven is specifically
designed to heat or cook. It is not designed for industrial or laboratory use. The use of
corrosive chemicals in heating or cleaning will damage the appliance.
During initial power up, this appliance performs a self-test of the door locking mechanism.
The lock symbol will flash during the test. The door must remain closed until after the symbol
stops flashing. If the door is open or an attempt is made to open it during the test it may cause
damage to the lock mechanism and result in an error code.
The test is performed at initial power up and subsequently any time power has been cut and
resumed. (For example, after a power outage.)
If error occurs, refer to "SOLVING OPERATIONAL PROBLEMS" on page 42.
4
©2019 Hestan Commercial Corporation
THE DOOR MUST REMAIN CLOSED WHEN POWER IS INITIALLY
SUPPLIED TO THE APPLIANCE .
(CONT.)