hestan KDO Use And Care Manual page 42

OVEN CARE AND CLEANING
REPLACING AN OVEN LIGHT
Each oven is equipped with three halogen lights per cavity located in the side walls of the oven.
EN
• The lenses must be in place when using the oven.
The lenses serve to protect the light bulb from
breaking.
• The lenses are made of glass. Make sure the
glass lens is cool to the touch. Handle carefully
to avoid breakage. Broken glass could cause an
injury.
• Use only 20 watt, 12 Volt, halogen "Bi-Pin" bulbs
suitable for appliance oven use. This type of
bulb may be available at hardware stores & home
centers, or specialty lighting stores.
Contact Hestan Customer Service for more
information.
TO REPLACE A LIGHT BULB
1. Turn off power at the main power supply (fuse
or breaker box).
2. Place a thick towel or cloth on the oven floor below the
lamp to catch the glass lens should it fall.
3. Remove the lens retaining screw using a screw driver.
Then remove the lens.
4. Remove the light bulb from its socket by pulling it
straight out.
5. Before installation, it is very important to clean the new
bulb carefully with a clean, soft cloth, or tissue paper.
Grease, fingerprints, or oils in your skin can leave a
residue on the glass surface of the bulb which will create
a hot-spot. The bulb will eventually crack at this hot-
spot.
6. While still using a cloth or tissue paper, insert the new
bulb in the lamp housing. Push the bulb fully into the
socket.
7. Replace the lens and screw.
Replace the rack supports if provided. Turn power back on
at the main power supply (fuse or breaker box).
40
©2019 Hestan Commercial Corporation
(CONT.)
ELECTRICAL SHOCK HAZARD - Make sure the power has been
shut off to the range. The light socket is energized when the door is
open. Failure to shut off the power when replacing a light bulb
could result in electric shock or burns.
OFF TEMP/PRESET
WARM/MIN
BROIL