Servicing Notes; Power And Plug Requirements - Canon Colortrac imagePROGRAF MFP Z36 Service Support Manual

Canon
IV. Servicing Notes
A.

Power and Plug Requirements

The imagePROGRAF printer requires a dedicated and properly grounded
single-phase 120V/15A NEMA 5-15 receptacle for proper operation.
Table 11 – Power and Plug Requirements
imagePROGRAF TZ-30000 MFP Z36
imagePROGRAF TX-4100 MFP Z36
imagePROGRAF TX-3100 MFP Z36
imagePROGRAF TM-305 MFPZ36
imagePROGRAF TM-300 MFPZ36
Colortrac Z36 MFP Scanner
Colortrac AIO Controller
Table 12 - Printer Main Unit Power Receptacle
imagePROGRAF Printer Main Unit and Colortrac Z36 Scanner Power Receptacle
IMPORTANT
•
Canon recommends an additional standard 120V/15A NEMA 5-15 outlet
for service tools, such as a laptop computer or vacuum that may be used
when servicing or configuring the machine.
•
Use only dedicated and properly grounded outlets for the imagePROGRAF
printer main unit. It is also strongly suggested to use dedicated and
properly grounded outlets for each optional accessory. Do not use
extension cords. The ground connection serves to provide the internal
electronics with a reference voltage. Faulty or poor ground sources will
cause this reference voltage to fall into a range that no longer serves as a
reliable reference voltage. The internal logic and programming of the
imagePROGRAF printers will not perform reliably because there is an
insufficient difference between the internal operating signal voltages and
the poor ground reference signal. A qualified electrician can measure and
provide the ground source that the imagePROGRAF printers or any
computer controlled office equipment requires.
•
Before installation, confirm that all necessary receptacles are available.
•
Phase converters and step down transformers are not supported
imagePROGRAF MFP Z36 Service Support Guide
Description
NEMA 5-15 Receptacle
imagePROGRAF MFP Z36 Service Support Guide
Power Supply
120 V/15 A outlet
Plug Specifications
NEMA 5-15
June 2021
Page 14