Table of Contents
Advertisement
1. Address
This section of the menu allows you to set the serial port addresses of the
individual inverters connected to the RS485 line.
The addresses that can be assigned are 2 to 63. The UP and DOWN
buttons scroll through the numerical scale.
'AUTO' selection cannot be used at present.
2. Display Set
This section of the menu allows you to set the display properties:
• Light: sets the lighting mode and adjusts the display backlight
• Contrast: adjusts display contrast (scale from 1 to 9)
• Buzzer: sets button sound
3. Service
This section of the menu is reserved for installers.
A special access password is required, which may be obtained from the
website https://registration.solar.fimer.com.
Before connecting to the site, make sure you have all the information
required to calculate your password:
Inverter Model, Serial Number, week of manufacture.
When you have a password you can set the parameters in the menu.
Changing the above-mentioned parameters may prevent disconnection from the grid if the
new values exceed those given in the standards of the country of installation. If these para-
meters are changed to values outside the standard range, an interface protection must be
installed external to the inverter in accordance with the requirements of the country of instal-
lation.
- MODE:
ON: Light always on
OFF: Light always off
Auto: Automatic backlight control. The light is switched on
whenever a button is pressed and stays on for 30 sec, after
which it gradually dims out.
- Intensity: adjusts display brightness (scale from 1 to 9)
ON: button sound is on
OFF: button sound is off
7 - Operation
76
Advertisement
Table of Contents
