Charging From An Ac Power Source; Charging Status Leds; Charging Times And Transmitter Runtimes - Shure GLXD4RPE Manual

Charging from an AC Power Source

1. Plug the charging cable into the charging port on the transmitter.
2. Plug the charging cable into an AC power source.

Charging Status LEDs

LED Color
Green (solid)
Red (solid)
Amber (flashing)
Off

Charging Times and Transmitter Runtimes

Use the following table to determine approximate battery runtime based on the duration of charging time when in 5.8 GHz
mode. Times shown are in hours and minutes. Transmitters automatically power­off after approximately 1 hour to conserve bat­
tery life if the signal from a linked receiver is not detected.
Receiver Bay or AC Power Source Charging
0:15
0:30
1:00
3:00
*Storage time or excessive heat will reduce maximum runtime.
Description
Device is fully charged
Charging
Out of temperature range, or battery error
Power supply is disconnected, or no device is docked in the charging bay
Transmitter Runtime
up to 1:30
up to 3:00
up to 6:00
up to 11:30*
Shure Incorporated
11/39