Specifications; Functional Description - Milwaukee FUEL M18 FDG Operator's Manual

ADDITIONAL BATTERY SAFETY RULES
To reduce the risk of fire, personal
WARNING
injury, and product damage due to
a short circuit, never immerse your tool, battery
pack or charger in fluid or allow a fluid to flow inside
them. Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a
short circuit.
Do not charge non-rechargeable
WARNING
batteries.

SPECIFICATIONS

Cat. No. .................................................... M18 FDG
Volts............................................................. 18V DC
Battery Type .................................................M18™
Charger Type....................................................M18
Recommended Ambient
Operating Temperature ...................
Rated RPM ...................................................27,000
Max Wheel Ø .........................................50 mm (2")
Max Flap Disk Ø ....................................50 mm (2")
SYMBOLOGY
V
Volts
Direct Current
Rated Revolutions per Minute (RPM)
Read Operator's Manual
Wear Eye Protection
Wear Face Mask
Do not dispose of electric tools
together
material. Electric tools and electronic
equipment that have reached the end
of their
separately
environmentally compatible recycling
facility.
Regulatory Compliance Mark (RCM).
This product meets applicable
regulatory requirements.
-17°C to 52°C
(0°F to 125°F)
with household
life must be collected
and returned to

FUNCTIONAL DESCRIPTION

1
WARNING
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
may be hazardous.
Points, cones, plugs, grinding wheels and cut-off
wheels should be protected from:
• wetness and extreme humidity
waste
• any type of solvent
• extreme changes in temperature
• dropping and bumping
Points, cones, plugs, grinding wheels and cut-off
an
wheels should be stored:
• in an organised way so points, cones, plugs or
wheels can be removed without disturbing or dam-
aging other points, cones, plugs or wheels
• with their safety information
Points, cones, plugs, grinding wheels and cut-off
wheels should NOT be dropped, rolled or bumped.
Discard points, cones, plugs, or wheels that have
been dropped, rolled, bumped, subjected to extreme
changes in temperature, or come into contact with
solvents or wetness.
The collet must be attached to the collet nut before
installing the collet asembly to the tool. Be sure that
the collet size matches the size of the mandrel you
will use, otherwise the collet may break.
1. To assemble, place collet on an even surface, and
place the nut over the collet.
2. Press down on the nut to snap the nut and collet
together.
3. To disassemble, use a rod to push the collet out
of the nut.
5
3
2
1. Collet nut
2. Slide switch
3. Handle
4. Dust screen
5. 17 mm wrench (not shown)
6. 15 mm wrench (not shown)
7. 6.35mm (1/4") collet (not shown)
8. 6mm collet (not shown)
9. 8mm collet (not shown)
ASSEMBLY
Recharge only with the charger
Always remove battery pack before
changing or removing accessories.
recommended for this tool. Others
Accessories
Installing Collets
4
-