Specifications; Functional Description - Milwaukee 2785-20 Operator's Manual

SPECIFICATIONS

Cat. No. ..................................................... 2785-20
Volts .............................................................. 18 DC
Rated RPM .....................................................6 600
Spindle Thread Size .................................... 5/8"-11
Max Capacity ...........................................7"/9"x1/4"
Battery Type .................................................M18™
Charger Type ................................................M18™
Recommended Ambient
Operating Temperature ......................0°F to 125°F

FUNCTIONAL DESCRIPTION

2
1
9
8
1. Spindle lock
2. Side handle
3. Handle
SYMBOLOGY
Volts
Direct Current
Rated Revolutions per Minute (RPM)
UL Listing Mark for Canada and the U.S.
US
C
3
6
5
4
7
4. Switch
5. Switch lock-off
6. Dust screen
7. Guard
8. Guard lock lever
9. Accessory
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
To reduce the risk of injury when grinding, always
use properly installed guards.
This tool is shipped with a guard. The guard must be
used when using the tool as a grinder. When used
as a Sander, it must be removed.
Installing/Removing/Adjusting the Guard
1. To install the guard, remove battery pack and
place it upside down on a level surface. Remove
any accessories from the spindle. WARNING!
Always remove battery pack before changing or
removing accessories.
Line up the tabs with the tab slots. Then press the
guard down onto the tool.
Tab slot
Guard
adjustment
lock lever must
engage one of
the detents
Press in the guard adjustment lock lever and rotate
the guard to one of the detent slots. The lock lever
must engage with one of the detents.
2. To adjust the guard, press in the guard adjust-
ment lock lever and rotate the guard to one of
the detents. WARNING! Always adjust the guard
to provide the operator with maximum protection
while operating.
3. To remove the guard, remove battery pack and
place it upside down on a level surface. Remove
any accessories from spindle.
Press in the guard adjustment lock lever and rotate
the guard to line up the tabs with the slots. Then
lift the guard straight up and away from the tool.
5
Tab slot