Functional Description; Specifications - Milwaukee M18 2686-20 Operator's Manual

• Always operate with two hands.
• Always use common sense and be cautious when
using tools. It is not possible to anticipate every
situation that could result in a dangerous outcome.
Do not use this tool if you do not understand these
operating instructions or you feel the work is beyond
your capability; contact Milwaukee Tool or a trained
professional for additional information or training.
• Maintain labels and nameplates. These carry
important information. If unreadable or missing,
contact a MILWAUKEE service facility for a free
replacement.
• Some dust created by power sanding,
WARNING
sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• lead from lead-based paint
• crystalline silica from bricks and cement and other
masonry products, and
• arsenic and chromium from chemically-treated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are spe-
cially designed to filter out microscopic particles.

FUNCTIONAL DESCRIPTION

1
8
7
6
1. Side handle
2. Spindle lock
3. Handle
4. Paddle switch
5. Guard
6. Accessory
7. Guard lock lever
8. Side handle sockets
9. Switch lock-off
10. Type 1 clip-on guard

SPECIFICATIONS

Cat. No. ..................................................... 2686-20
Volts .............................................................. 18 DC
Battery Type .................................................M18™
Charger Type ................................................M18™
Rated RPM ...................................................11,000
Spindle Thread Size .................................... 5/8"-11
Max Capacity ....................................................... 5"
Recommended Ambient
Operating Temperature .................... 0°F to 125°F
3
2
4
5
9
10
SYMBOLOGY
Volts
Direct Current
Rated Revolutions per Minute (RPM)
Do not use this type of guard for
cut-off operations.
Read Operator's Manual
UL Listing for Canada and U.S.
C US
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always lock the trigger or remove
WARNING
the battery pack any time the tool
is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
To reduce the risk of injury when
WARNING
grinding, always use properly in-
stalled guards. The guard type must match the
wheel type to provide maximum protection for
the operator if the wheel should break.
Only use accessories specifically recommended
for this tool. Others may be hazardous.
Installing/Adjusting/Removing the Guard
This tool is shipped with a guard. A guard must be
used when using the tool as a grinder. The guard may
be removed when using tool as a sander.
1. To install the guard, remove the battery pack and
remove any accessories from the spindle.
NOTE: Only use 4-1/2" accessories with 4-1/2"
guards. Only use 5" accessories with 5" guards.
2. Press and hold the spindle lock and unscrew the
flange nut and backing flange.
3. Line up the tabs on the grinder with the slots in
the guard, push down, and twist left to engage.
Detent
slots (5)
5
Tab
slots (6)