Table of Contents
Advertisement
Installation instructions
Transporting the appliance
1.
During transport or storage, the heat pump water heater should
remain in undamaged packaging to prevent damage to the appliance.
2.
During long periods of transport or storage, the heat pump water
heater must be in an upright position.
3.
For short distance transportation (under one hour), this product may
be laid down within 1 hour as per indication on packaging. If laid
down, the appliance must be at an upright position for 4 hours prior
to its initial startup.
Selection of installation site
Ensure the install location is stable and level, and that air can flow in and out freely,
1.
and will be minimally affected by wind.
The base or surface can support the filled weight of the appliance and the
2.
condensate water can be drained freely.
3.
If installed on a base, ensure that this base is level to allow correct drainage
via the condensate drain at the rear of the appliance.
4.
The location or position of the appliance will not create nuisance
noise for the homeowners or neighbors, especially through proximity
to bedrooms.
5.
Ensure that the location allows condensate and PTR valves to be
drained into an area that will not cause damage to the surrounding
area.
There is sufficient space left for installation and maintenance of the appliance.
6.
7.
There is no strong electromagnetic interference around the appliance
that may affect its control functions.
8.
There are no corrosive vapors such as aerosol sprays, stain removers or
household chemicals near the install location. These vapors may corrode the
appliance and its fittings.
9.
Considerations have been made to prevent water pipes from freezing in colder
regions.
12
Advertisement
Table of Contents
