Items Supplied; Charging - Silvercrest 93480 Operating Instructions Manual

Hair & beard clippers
Hide thumbs Also See for 93480:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 4
__GRA93480_B4.book Seite 7 Montag, 9. September 2013 9:12 21
Do not cover the power unit to prevent overheating.
The blades of the shaving head may only be cleaned with medical alcohol.
Do not use any water or other liquids.
Do not use any astringent or abrasive cleaning agents.

4. Items supplied

1 hair and beard trimmer
1 power unit
2 adjustable comb attachments:
Attachment 1: 4/7/10/13/16 mm
Attachment 2: 18/21/24/27/30 mm
1 comb
1 scissors
1 cleaning brush
1 oil
1 storage pouch
1 set of operating instructions

5. Charging

NOTES:
Before the device is used for the first time, and during the following three
charging procedures, the device should be charged for 10 hours in each
case.
When the battery is almost flat, the charging indicator changes colour from
green to red during operation. The device can then only be used for a short
time without being connected to the electricity supply.
1. Switch off the device with the on/off switch|5 if necessary.
2. Connect the power unit to the connector|7 of the device.
3. Insert the power unit into a readily accessible wall socket whose voltage
matches the voltage stated on the rating plate.
4. The charging indicator|6 flashes red and the battery is charged. When the
battery is fully charged, the charging indicator flashes green. When the
battery is fully charged, the device can be used for approximately 60 min-
utes without being connected to the power supply.
GB
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Shbs 500 b1

Table of Contents