Endress+Hauser mycom CLM 152 Operating Manual page 97

T emperature sensor 2 Input contacts
PT 100
PT 1000 (only for
(only with FCXI)
W
NTC 30 k d ifference)
tag number Profibus address
(only FCYP)
Remote meas. range Meas. current
switch-over (linear) ranges 1-4
Meas. ranges 1-4 at 0/4 mA
Remote meas. range
Meas. current range
switch-over (bilinear): at 20 mA
Meas. range 1-4
Temperature value Temperatue value
at 0/4 mA at 20 mA
Support points
Tc table
Tc curve
Tc table
Limit Hysteresis
On delay Off delay
Interval cleaning Cleaning cycle
Hour
Minute
Second
Week program Set
Cancel
Temperature sensor 1 Temperature sensor 2
PT 100
PT 1000
(only for difference)
NTC 30 kW
Failure relay
Namur contacts
NC contact Fleeting contact
NO contact Steady contact
Contrast
Meas. current range
at 20 mA
Value at knee point
NC contact
NO contact
Day Mon=1 ... Sun=7 Next day
Number of starts Cancel
Unit for temp. meas. Temperature setting
Celsius
manual (MTC)
Fahrenheit
automatic (ATC)
Kelvin
Assign faults
Start-up
to maintenance contact
End
to no contacts
Resume
Pre-rinse Clean
No. of repetitions Hold
without cleaning agent on
off
Compensation temp. 1 Compensation temp. 2
(only for difference
(only with MTC)
and MTC)
Post-rinse No. of repetitions
Hold continuation Display cleaning period
(only for Hold on)