Mitsubishi Electric Melservo JE Series Instruction Manual page 259

12. ABSOLUTE POSITION DETECTION SYSTEM
12.1.2 Configuration
The following shows a configuration of the absolute position detection system. Refer to section 11.5 for the
connection of the battery.
12.1.3 Parameter setting
Set "_ _ _ 1" in [Pr. PA03] to enable the absolute position detection system.
12.1.4 Confirmation of absolute position detection data
You can check the absolute position data with MR Configurator2. Choose "Monitor" and "ABS Data Display"
to open the absolute position data display screen.
Servo system controller
[Pr. PA03]
1
Absolute position detection system selection
0: Disabled (used in incremental system)
1: Enabled (used in absolute position detection system)
12 - 2
Servo amplifier
CN1A CN2
CN4
Battery
Servo motor