Replace The Rtd - Nordson AD-31 Series Customer Product Manual

Replace the RTD

1
Figure 27 Lock Positions
1. Unlocked
E 2005 Nordson Corporation
WARNING: Hot! Risk of burns. Wear long-sleeved, heat-protective
clothing; safety goggles; and heat-protective gloves.
1. Relieve system pressure. Refer to Safety.
WARNING: Disconnect and lock out input power. Failure to do so can
result in serious injury, including death.
2. Disconnect and lock out input power to the melter main circuit breaker.
3. See Figure 27. Place the trigger in the locked position.
2
2. Locked
4. Use a Phillips screwdriver and unscrew the screws holding the pivot
sleeve shells together.
NOTE: Figure 28 shows a typical handgun. Details may vary depending
upon the gun model.
Typical RTD Removal
Figure 28 Remove the Pivot Sleeve Shells (typical gun shown
RTD Removal for a 3−Station
Terminal Block
33
AD-31 Hand Guns
Part 107105C04