Table of Contents
Advertisement
16
AD-31 Hand Guns
Ì Ì
Ì Ì
Figure 9 Connect the Electrical
Switch
Part 107105C04
Electrical Switch Connections (if applicable)
1. Find the orientation lug on the hose-cordset connector and ensure that
the connector and switch plug at the bottom of the handgun's handle are
properly aligned.
2. Attach the switch plug assembly at the bottom of the handle to the
connector on the hose cordset.
3. Refer to the melter manual to complete the hose installation to the
melter.
Configuration B: AD-31 RTD Style Other than Series
5000
Connecting the RTD Sensor
Refer to Figure 10 as necessary.
Heater
Terminal
Block
L1, Heater (Wire 1)
L2, Heater (Wire 2)
Heater
Figure 10
Wiring Diagram
1. Loosen the two screws from the RTD terminal block as shown in Figure
11. Insert wires 3 and 5, extending from the hose, into the terminal
block.
RTD
Terminal
Ground
Block
RTD (Wire 5)
RTD (Wire 3)
RTD
E 2005 Nordson Corporation
Advertisement
Table of Contents
