Hose/Gun Connection; Connect The Hose - Nordson AD-31 Series Customer Product Manual

12
AD-31 Hand Guns

Hose/Gun Connection

Figure 2 Remove Pivot Sleeve
Shells (typical gun
shown)
Part 107105C04
WARNING: Hot! Risk of burns. Wear heat-protective clothing, safety
goggles, and heat-protective gloves.

Connect the Hose

Handguns are shipped fully assembled. To connect the hose to the
handgun, partially disassemble the handgun.
1. With a Phillips screwdriver, remove the screws that secure the pilot
sleeve shells.
NOTE: Figure 2 shows a typical handgun. Details may vary depending
upon the gun model.
2. Remove the cap plug on the swivel connector.
CAUTION: Align each set of electrical wires exiting the hose with a groove
on the pivot sleeve. Failure to do so can damage the wires, resulting in an
electrical short. See Figure 3.
   Â
   Â
   Â
   Â
Figure 3 Proper Wire Alignment
   Â
   Â
   Â
   Â
E 2005 Nordson Corporation