Vi.2 Openable Panel; Vi.3 Activated Carbon Filter (For Filtering Hoods); Vi.4 Hood Cleaning; Vi.5 Lighting - Galvamet HIDE Installation, Operating And Maintenance Manual

VI.2 Openable panel

The openable panel can be washed when the notice to clean the metal filters appears or at least once a month with hot
water and detergent.
If necessary, to remove the panel, follow the instructions in Fig. 6.2.1 and Fig. 6.2.2. It is recommended not to wash it
in the dishwasher and to reassemble the panel only if it is perfectly dry.
Caution! Grease retained in the opening panel is highly flammable.
The panel must therefore be cleaned regularly.

VI.3 Activated carbon filter (for filtering hoods)

The activated carbon filters, if present, have the function of retaining the odors present in the cooking fumes.
The purified air is recycled into the room. The activated carbon filters must not be washed and must be replaced 3 or 4
times a year depending on the use of the hood. Request the filters to the manufacturer.
To install the activated carbon filters, the metal grease filter must first be removed (Fig. 3.2.3).
At this point, without the use of tools, install the active carbon odour filters by hooking them in rotation to the clips on
the sides of the motor (Fig. 6.3.1).
To replace the activated carbon filters, repeat the described operations backward.

VI.4 Hood Cleaning

The hood must be cleaned immediately after installation and removal of the protective film to eliminate any residual
adhesive or other impurities. The hood must be cleaned frequently both internally and externally (at least once a month).
Do not allow dirt to accumulate on the surfaces of the hood.
Do not use acid or basic products or abrasive sponges to clean the external parts of the hood. Clean the hood with a
sponge moistened with hot water and a small quantity of neutral soap (for example dish soap) to eliminate any grease
particles that may have deposited.
Rinse with a damp cloth, carefully remove all the soap, following the direction of the satin finish of the steel surface.
Drying is particularly important, especially in areas where the water is very hard and leaves limescale deposits.

VI.5 Lighting

The hood is equipped with LED lighting which, in addition to offering excellent lighting and limited energy consumption,
guarantee a considerable duration over time. In case of replacement, contact the assistance service.
VII DISCONTINUATION
The discontinuation means the definitive shutdown and disassembly of the appliance.
After discontinuation, the appliance can be installed on another piece of furniture, privately resold, or disposed of.
Caution! For discontinuation, it is necessary to switch the appliance off and disconnect the power
Disassembly requires that the device is accessible and has been disconnected from the power supply.
To do this, follow the installation instructions in reverse order.
This appliance is marked under the European Directive 2012/19/EC, Waste Electrical and Electronic
Equipment (WEEE).
The symbol on the product or the packaging indicates that the product should not be considered as
normal household waste, but must be taken to the appropriate collection point for the recycling of
electrical and electronic equipment.
The appropriate disposal of this product helps to avoid potential negative consequences for the
environment and health. For more detailed information, contact your local office, local waste disposal
service, or the shop where you purchased the product.
11