VTech Analogue Contemporary Series User Manual page 8

Installation option - converting
from desktop to wall mount position
To mount the telephone base on the wall
1. Set aside the handset. On the telephone
base cradle, place a coin in the slit of
the wall mount clip and rotate a half turn
(180 degrees).
• It locks into place with the protruding
edge pointing towards the upper edge of
the telephone base. This protruding edge
holds the corded handset when the phone
is mounted on the wall.
2. Unplug the telephone line cord from the
telephone wall jack. Then press the large
tab on the upper groove on the telephone
base.
3. Turn the mounting bracket upside down.
Remove the telephone line cord from the
wire duct and then route it through the
groove on the bottom part the mounting
bracket. Insert the small tabs on the
mounting bracket into the upper slots
on the telephone base. Then press the
large tab on the mounting bracket and
firmly push it into the lower groove on the
telephone base.
4. Mount the telephone base on the wall by
aligning the eyelets with the mounting
studs of the wall plate. Then slide the
telephone base down on both mounting
studs until it locks into place. Place the
handset on the telephone base cradle.
EN - 8