Specifications; Troubleshooting; Completing Units - Electrolux ECH/BM-1200 3BI-W EEC User Manual

Troubleshooting

Malfunction
symptom
No heating
Smell of burnt dust
when first turned on
If after trying all the troubleshooting steps, the problem is not resolved, contact an authorized service cen-
ter in your area or your sales representative.

Specifications

Model
Power, W
Rated power consumption, W
Rated current, A
Rated voltage, V~Hz
Ingress protection class
Electrical protection class
Heating area, m
2
Appliance size (W×H×D), mm
Packing size (W×H×D), mm
Net weight, kg
Gross weight, kg
* Indicated is a guideline value and may differ depending on actual conditions of use
The convector is supplied with a sticker on
the front panel. Remove it before using the
device.
Troubleshooting
E1 – Temperature sensor failure;
E2 - Short circuit on the temperature sensor
channel;
E3 - Temperature sensor overheated. Current
temperature exceeded +48˚C;
E4 - The ambient temperature has fallen
Cause of malfunction
1) There is no power supply.
2) The convector is in standby mode.
3) The actual room temperature is higher
than the thermostat setting.
Not a malfunction
ECH/BM-1200 3BI-W EEC
1) Establish a reliable connection.
2) Set the convector to operating
mode.
3) Adjust the temperature mode of the
convector.
The smell disappears after a few
minutes of convector operation
1200
1050
4.77-5.0A
220/240~50/60
IP24
I
10-12
640x112x424
750x142x468
7,1
8,4
below the permissible operating temperature
of the unit (below -26 ˚C);
С1 – There is no connection to the Internet;
С2 – There is no connection to the route;
С3 – No connection to the server.

Completing units

1. Electric heater
2. Wall mounting bracket
3. Mounting template
4. A set of fasteners
5. Operation manual
6. Chassis set with wheels
ENGLISH
Troubleshooting steps
ECH/BM-1600 3BI-W EEC
1600
1400
6.36-6.67A
220/240~50/60
IP24
I
14-16
800x112x424
910x142x468
8,2
9,6
9