Bake Element; Broil Element; Oven Sensor; Electronic Clock - Maytag JENN-AIR JDR8895AAB Service Manual

Disassembly Procedures
!
WARNING

Bake Element

1. Disconnect power before servicing.
2. Remove oven door for easier accessibility, see "Oven
Door(s)-Door Removal" procedure.
3. Remove screws securing bake element to back of
oven cavity.
4. Gently pull element through cavity wall until terminals
can be accessed.
5. Label and disconnect wiring and remove element.
6. Reverse procedures to reassemble.

Broil Element

1. Disconnect power before servicing.
2. Remove oven door for easier accessibility, see "Oven
Door(s)-Door Removal" procedure.
3. Remove broil element support brackets.
4. Remove screws securing broil element to back of
oven cavity.
5. Gently pull element through cavity wall until terminals
can be accessed.
6. Label and disconnect wiring and remove element.
7. Reverse procedures to reassemble.

Oven Sensor

The oven sensor is located inside oven cavity, attached to
the upper left rear wall of the cavity.
1. Disconnect power before servicing.
2. Open oven door and remove screws securing sensor
to oven cavity.
NOTE: Gently pull wiring through cavity wall.
3. Disconnect sensor at connector block and remove.
4. Reverse procedures to reassemble.
NOTE: Verify connect is pushed through the insulation.

Electronic Clock

1. Disconnect power before servicing.
2. Remove vent deflector by removing screws located on
the underside of the control panel.
3. Remove screws securing backguard panel to
backguard housing. (Screws are located on the
bottom and back side of control panel.)
4. Lift control panel up, tilt forward, and lay panel on a
protected surface of the maintop for servicing.
5. Remove screw securing mounting plate to backguard.
6. Disconnect wiring and remove control.
7. Reverse procedures to reassemble.
22
To avoid risk of electrical shock, personal injury, or death:
disconnect electrical and gas supply before servicing.

Oven Light Replacement

The oven light used is a 120 volt, 20 watt Halogen bulb.
The light automatically illuminates when the door is
opened, or may be manually activated when the door is
closed via the light pad. The light will not operate during a
clean cycle. The oven light automatically illuminates one
minute before the end of a clock-controlled cooking
operation.
1. Disconnect power before servicing.
2. Open oven door and locate oven light.
3. Grasp lens cover and pull outward on one side to gain
access to bulb.
4. Carefully remove old bulb, by lifting bulb straight out
of ceramic base.
NOTE: To avoid damaging the new bulb and decreasing
life of the bulb, do not touch new bulb with bare
hands or fingers.
Hold with a cloth or paper towel.
5. Reverse procedures to reassemble.
G5.3 Type Halogen Bi-Pin 120 volt, 20 watt

Oven Door(s)

Do not place excessive weight on an open oven door or
stand on an opened door as, in some cases, it could
cause the range to tip over, breakage of the door, or
serious injury.
Both the upper and lower oven doors are removable.
NOTE: DO NOT LIFT OVEN DOOR USING HANDLE.
Damage to the oven door and personal injury
may occur.
16023417
Get other manuals https://www.bkmanuals.com
Bulb
Socket
Lens
Bulb specifications:
©2004 Maytag Services