IBM 6029 Hardware Maintenance Manual page 32

3. To locate the DIMM connectors. See "Identifying parts on the system board" on
4. Open the retaining clips.
5. Make sure the notches in the DIMM align with the tabs on the connector. Push
To remove a DIMM:
1. Remove the cover. See "Removing the cover" on page 23.
2. You might have to remove an adapter to gain access to the DIMM slots. See
3. To locate the DIMM connectors. See "Identifying parts on the system board" on
4. Open the retaining clips.
5. Lift the DIMM out of the DIMM slot.
6. Close the retaining clips.
26
Hardware Maintenance Manual
page 24.
or insert the DIMM straight down into the connector until the retaining clips
close.
Notches
"Installing and removing adapters" on page 27.
page 24.
What to do next:
v Replace any adapters that were removed.
v Replace the power supply.
v To work with another option, go to the appropriate section.
v To complete the installation, go to "Replacing the cover and connecting the
cables" on page 33.