Clean The Sensor Filter - Hasselblad X1D-50c User Manual

Troubleshooting
6.4

CLEAN THE SENSOR FILTER

Caution!
Be careful when you attach/remove the components to/from
the camera. This will help prevent damage to the data bus
connections.
Caution!
When you remove the lens, keep foreign objects away from the
camera opening. The camera opening is very sensitive. This will
help prevent damage to the equipment.
Remove the Lens and clean the Sensor
1 Remove USB 3 cable if connected.
2 Press and hold the Lens Release button.
3 Rotate the Lens counter clockwise.
4 Remove the lens.
5 Carefully clean the outside surface of IR filter by using clean
compressed air.
Caution!
If you use canned compressed air to clean the glass of IR filter,
read the instructions very carefully before use. This will help
prevent damage to the filter.
If compressed air did not remove all the problems on the filter,
use an E-wipe. Do as follows:
6 Tear at the notch to break seal.
7 Remove an E-wipe from the package and fold the tissue to
match the width of the IR filter.
8 Apply firm pressure using two or three fingers at the edge of
the wipe to ensure an even, firm contact with filter surface.
9 Wipe the surface in one unbroken motion.
Note!
Do not use same side of the E-wipe twice as you will be likely to
reapply particles removed in the first pass.
10 Attach the Lens again to the camera immediately after
cleaning.
11 Capture a number of images.
12 Inspect the images.
If you still see spots on your images, you may have dust either
on the inside of the IR filter or on the CMOS itself, please
contact your Hasselblad dealer.
X1D
Caution!
Do not try to remove the glass IR filter from the front of the
sensor (due to dust or similar). This will cause damage to the
equipment.
Table of Content
USER GUIDE
www.hasselblad.com
147