Table of Contents
Advertisement
Installing Control Panel
Choose most suitable method of communication between Control Panel and Control Box.
Wireless mode:
1.
Install batteries into Control Panel in accordance with instructions on page 12.
2.
Turn Control Box and Control Panel on.
3.
Pair Control Box and Panel together see page 13.
4.
Choose suitable location for Control Panel – press change sat button periodically to check wireless reception.
5.
When satisfied with the location of the Control Panel mark the position of the fixing holes on the
magnetic mount then attach to wall with 2 No.6 screws.
Cable mode:
1.
Choose a location to mount the Control Panel.
2.
Mark the fixing holes then make a pilot hole with a drill or bradawl.
3.
If required remove one of the knock outs with a pair of pliers.
4.
Pass cable through hole in Magnetic Mount.
5.
Screw the Magnetic mount to the wall with the RJ25 cable laying flat and un-twisted in the channel.
6.
Connect the Control Panel to the RJ25 cable and place onto Magnetic Mount whilst pulling through the cable.
Connection diagram:
TV
Satellite Receiver/s
Optional cable for Control Panel (also use as wireless)
Key:
A:
Satellite Cable
B:
Satellite Cable. Note: For Skew variants, satellite cable labelled 'Control Box' must
be routed to 'B'
C:
Antenna Cable
Visit: www.seekerwireless.co.uk for potential software updates
(Sat Cable labelled 'Control Box' - Skew only)
D
B
C
D:
Cable for PVR or additional Satellite Receiver
Knock-outs
Knock-outs
for vertical
for vertical
cable routing
cable routing
A
5A Fuse
- +
Ignition
Page 11
Advertisement
Table of Contents
