Top Cover And Bezel - IBM x3950 Problem Determination And Service Manual

2. Position the ServeRAID-8i adapter so that the metal locking clasp is at the rear
3. Install the top cover (see "Top cover and bezel").
4. Slide the server into the rack.
5. Connect the cables and power cords (see "Connecting the cables" on page 120
6. Turn on all attached devices and the server.

Top cover and bezel

Attention:
removed might damage server components. For proper cooling and airflow, replace
the top cover before turning on the server.
To remove the top cover and bezel, complete the following steps:
1. Read the safety information that begins on page "Safety" on page vii and
2. If you are installing or replacing a non-hot-swap component, turn off the server
3. Slide the server out of the rack until the slide rails lock into place.
4. Lift the cover-release latch. The cover slides to the rear approximately 13 mm
5. Press on the bezel retention tabs at the top edge of the bezel, and pull the top
6. Lift the bezel up to release the tabs at the bottom edge of the bezel.
7. If you are instructed to return the cover and bezel, follow all packaging
To install the top cover and bezel, complete the following steps:
1. Make sure that all internal cables are correctly routed.
Attention: Incomplete insertion might cause damage to the server or the
ServeRAID-8i adapter.
of the server; then, press the ServeRAID-8i adapter firmly into the connector.
for cabling instructions).
Operating the server for more than 2 minutes with the top cover
"Installation guidelines" on page 117.
and all peripheral devices, and disconnect the power cords and all external
cables.
Top cover
Bezel
(0.5 inch). Lift the cover off the server.
of the bezel slightly away from the server.
instructions, and use any packaging materials for shipping that are supplied to
you.
Cover release
latch
Chapter 4. Removing and replacing server components
131