Verify The Pa-7000 Series Firewall Npc Configuration - PaloAlto Networks TECHDOCS PA-7000 Series Hardware Reference Manual

PA-7000 Series Firewall Installation
card serial
Disk id B2
model
size
status
card serial
The output also shows the model, size, status, and the AMC serial number. For information on
replacing a failed drive and commands to add and remove drives, see
Firewall LPC Drive.
The following table describes the possible status levels for a drive:
Table 2: AMC Status Indicators
Status
not in use
spare rebuilding
active sync
failed

Verify the PA-7000 Series Firewall NPC Configuration

When you first set up a PA-7000 Series firewall, all NPC slots are ready to use. If you are working
with a firewall that is already deployed, you should check slot status before adding a new NPC
to ensure that the NPC slot is ready. If the firewall is in a high availability (HA) configuration, a
newly installed NPC stays in a disabled state until a matching NPC is installed. After you install a
matching NPC in the same slot number in the HA peer firewall, you must enable the NPCs.
The following commands describe how to view NPC status and how to change the state of an
NPC.
To view NPC status, run the following command:
admin@PA-7050> show chassis
status slot <slot-number>
For example, to view the status of slot 3 run the following command:
admin@PA-7050> show chassis
status slot s3
If an NPC slot is ready to use, the status shows empty. When you insert an NPC, the system
updates the status of the slot.
PA-7000 Series Firewall Hardware Reference
: 002901000089
: ST91000640NS
: 953869 MB
: active sync
: 002901000076
Description
The drive is not part of a RAID pair.
After replacing a failed drive in a RAID 1 pair, this status
message indicates that the firewall is synchronizing data from
the existing drive to the new drive.
The drive is ready and is currently part of a RAID 1.
The drive has failed and must be replaced.
125
Present
Replace a PA-7000 Series
2023 Palo Alto Networks, Inc.
©