Table of Contents
Advertisement
Quick start guide
Checking the printer
voltage
Connecting the printer
Make sure that the device has been set to the correct voltage (e.g. 230 V in Europe,
120 V in the USA). To do this, check the type plate at the back of the printer. Con-
tact your dealer if the setting is incorrect.
Never switch on the printer if the voltage setting is incorrect, since this may result
STOP
in severe damage.
Connect the power cable to the power inlet of the printer.
Connect the power cable plug to a mains socket.
Make sure that the printer and the computer are switched off
and connect the data cable between the printer and the com-
puter, in this example a 36-pin centronics parallel cable.
Installation
7
Advertisement
Table of Contents
Need help?
Do you have a question about the Tally T5040 and is the answer not in the manual?