Advertisement
Card stock/ Custom-sized paper
Postcards, cards and other custom-sized materials can be printed with this
machine.
•
Do not print on media smaller than 76 mm (3.00 inches) wide or 127 mm
(5.00 inches) long.
•
In the software application, set margins at least 6.4 mm (0.25 inches)
away from the edges of the material.
Letterhead/ Preprinted paper
SINGLE-SIDED
Tray1
Face down
Manual tray
Face up
•
Letterhead/ Preprinted paper must be printed with heat-resistant ink that
will not melt, vaporize, or release hazardous emissions when subjected
to the machine's fusing temperature for 0.1 second. Check your
machine's specification to view the fusing temperature. (See "General
specifications" on page 67.)
•
Letterhead/ Preprinted paper ink must be non-flammable and should not
adversely affect machine rollers.
•
Forms and letterhead should be sealed in a moisture-proof wrapping to
prevent changes during storage.
•
Before you load letterhead/preprinted paper, verify that the ink on the
paper is dry. During the fusing process, wet ink can come off preprinted
paper, reducing print quality.
Photo
•
Make sure not to use the inkjet photo paper with this machine. It could
cause damage to the machine.
DOUBLE-SIDED
Face up
Face down
Media and tray_ 40
Glossy
Load one paper to the manual tray at a time, glossy side facing up.
•
Recommended media: Glossy paper (Letter) for this machine by HP
Brochure Paper (Product: Q6611A) only.
•
Recommended media: Glossy paper (A4) for this machine by HP
Superior Paper 160 glossy (Product: Q6616A).
USING THE OUTPUT SUPPORT
The surface of the output tray may become hot if you print a large
number of pages at once. Make sure that you do not touch the
surface, and do not allow children near it.
The printed pages stack on the output support, and the output support will
help the printed pages to align. The printer sends output to the output tray
by default. To use the output tray, make sure that the rear cover is closed.
Advertisement
