Westfalia 92 86 29 Original Instructions Manual page 30

With plenty of paint move it faster. Do not spray in an arc on the
surface and do not interrupt spraying as this will lead to uneven or too
little paint distribution onto the surface. The general recommended
spraying distance is about 20 cm.
If the finish is too wet, reduce the amount of paint with the paint flow

regulator (1c).
Always keep the spray gun in a constant distance to the surface to be

sprayed. Move the spray gun evenly and in parallel lanes from one side
to the other.
Start spraying openings and corners of the object. If necessary, take a

short break after each spraying process, so the solvents may start
flashing off. Each lane should overlap to at least 50 %. Move the gun
evenly and always horizontal to the object. Always work from top to
bottom. Move the spray gun over the edges of the object so that the
edges get enough paint.
If you do not use the spray gun for a short time, hang it on the

suspension eye Turn off the air supply and release the pressure.
Check the paintwork on all sides, before cleaning the spray gun. After

work empty the paint container into an appropriate bin. Properly
dispose of coating material that is no longer needed.
Recently treated surfaces must not be exposed to direct sunlight, to

very high or low temperatures, wind, dust, water or rain.
1) Gravity Spray Gun
26