Table of Contents
Advertisement
4
4 ELECTRICAL INSTALLATION
Serial Interface models are equipped with a cable terminated by a 25-pin male D-sub
connector for connection to the power supply and input/output signals. For Ethernet models,
an accessory 17-pin to 25-pin cable is available for CBX connections.
We recommend making system connections through one of the CBX connection boxes since
they offer the advantages of easy connection, easy device replacement and filtered
reference signals.
NOTE: If you require direct wiring to the scanner, the details of the connector
pins and relative connections are indicated in Appendix A for Serial models or
in Appendix B for Built-in Ethernet models.
NOTE: Profinet-IO models do not connect to the CBX connection boxes. The
details of the connector pins and relative connections are indicated in
Appendix C.
The table below gives the pinout of the CBX100/500 terminal block connectors. Use this
pinout when the DS5100 reader is connected by means of the CBX100/500:
Vdc
Power Supply Input Voltage +
GND
Power Supply Input Voltage -
Earth
Protection Earth Ground
Power Source – External Trigger
+V
I1A
External Trigger A (polarity insensitive)
I1B
External Trigger B (polarity insensitive)
Power Reference – External Trigger
-V
Power Source – Inputs
+V
I2A
Input 2 A (polarity insensitive)
I2B
Input 2 B (polarity insensitive)
Power Reference – Inputs
-V
+V
Power Source - Outputs
-V
Power Reference - Outputs
O1+
Output 1 +
O1-
Output 1 -
O2+
Output 2 +
O2-
Output 2 -
TX
Auxiliary Interface TX
RX
Auxiliary Interface RX
SGND
Auxiliary Interface Reference
REF
Network Reference
ID+
ID-NET network +
ID-
ID-NET network -
Shield
Network Cable Shield
56
CBX100/500 Terminal Block Connectors
Input Power
Inputs
Outputs
Auxiliary Interface
ID-NET
DS5100 REFERENCE MANUAL
Advertisement
Table of Contents
