Datalogic DS5100 Reference Manual page 43

INTRODUCTION
The Backup & Restore function is supported by the scanner when connected to or through:
 CBX + BM100 and/or BM2x0
 SC4000 ID-NET Controller
NOTE:

Before executing a Backup on a BM100 backup module make sure the
Write Protection switch is set to Unlocked.

If BM100 and BM2x0 are both installed B&R is automatically performed
only on the BM100 module.

BM2x0 can execute B&R only with Network up and running (network cable
connected).

QL500 can backup up to 10 nodes (Master + 9 slaves).

QL500 (Ethernet TCP/IP)
 QLM-Series Gateways
2
27