Location And Function Of Parts And Controls; Front Panel - Sony LMD-A240 Operating Instructions Manual

Location and Function of Parts and Controls

Front Panel

  (headphones) jack
The audio signal which is selected by the input select
button is output in stereo sound.
 Speaker
The audio signal which is selected by the input select
button is output in monaural sound (L + R).
The outputting audio can be changed in [Audio Setting]
(page 30) of the [User Configuration] menu.
The audio signals from the speaker are output from the
AUDIO OUT connector on the rear (see page 10).
Audio signals will not be output when headphones are
connected to the  jack.
Note
Do not input an audio signal that exceeds the speaker
output.
If the output audio is cracked or distorted, adjust the
volume.
 Input select buttons
Press to monitor the signal input to each connector.
SDI 1 button: to monitor the signal through the SDI
IN  connector
SDI 2 button: to monitor the signal through the SDI
IN  connector
HDMI button: to monitor the signal through the
HDMI IN connector
COMPOSITE button: to monitor the signal through
the COMPOSITE IN connector
6
Location and Function of Parts and Controls
 Function buttons
You can turn the assigned function on or off.
The factory setting is as follows;
F1 button: [Brightness]
F2 button: [Contrast]
F3 button: [Chroma]
F4 button: [Scan]
F5 button: [Marker]
F6 button: [Volume]
F7 button: [WFM/ALM/Vector]
You can assign various functions in [Function Button
Setting] (page 22) of the [User Configuration] menu.
The [Function Button Setting] menu can also be
displayed by pressing and holding the function button.
Press the button [Brightness], [Contrast], [Chroma],
[Volume], [WFM Line Position], [Phase], [Aperture] or
[Focus Gain] function assigned to display the
adjustment screen. Press the same button again, and the
adjustment screen disappears, but you can adjust the
value without the setting value display.
 Menu operation buttons
Displays or sets the on-screen menu.
Menu selection control
When the menu is displayed, turn the control to select
a menu item or setting value, and then press the
control to confirm the setting.
If the menu is not displayed and the menu selection
control is pressed, the characters that represent the
names of the buttons light up. Also, the names of the