Sony LMD-A240 Operating Instructions Manual page 11

Notes
 Use an HDMI cable bearing the High-Speed logo
(Sony product recommended).
 The HDMI audio signal is output only from [CH1] or
[CH2].
 SERIAL REMOTE connector (RJ-45)
Connect to the Sony BKM-16R/BKM-17R Monitor
Control Unit by using a 10BASE-T/100BASE-TX LAN
cable (shielded type, optional).
CAUTION
For safety, do not connect the connector for peripheral

device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
 When you connect the SERIAL REMOTE cable of the
unit to peripheral device, use a shielded-type cable to
prevent malfunction due to radiation noise.
The connection speed may be affected by the network

system. This unit does not guarantee the
communication speed or quality of 10BASE-T/
100BASE-TX.
 PARALLEL REMOTE connector (RJ-45, 8-pin)
Forms a parallel switch and controls the monitor
externally.
CAUTION
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
Pin assignment
Pin number Functions
1 Designating [SDI1] input signal
2 Designating [SDI2] input signal
3 Designating [HDMI] input signal
4 Designating [Composite] input signal
5 GND
6 [WFM/ALM/Vector]
7 [Tally Green]
8 [Tally Red]
You can assign functions using the [Remote] menu (see
page 32).
Wiring required to use the Remote Control
Connect the function you want to use with a Remote
Control to the Ground (Pin 5).
 HDMI cable holder
Secures the HDMI cable (Ø7 mm or less).
Close
Cable
Rotate to unlock the HDMI cable holder first, then
remove it.

(DC) input connector
Plug the DC power supply to this connector to provide
power to the monitor.
It runs on DC 12 V to 17 V.
CAUTION
Be sure to connect to a power supply of the specified
voltage.
Pin assignment
Pin number Functions
1 – (GND)
2 NC
3 NC
4 + (DC 12 V to 17 V)
 AC IN socket
Connect the supplied AC power cord.
Location and Function of Parts and Controls
11