Table of Contents
Advertisement
Mode Row Sets
The Mode Row Sets below show the 4 main modes in button control cells 5 thru 8 & their associated function pages for reference.
•
The Processing row applies signal processing to the selected path.
•
The Routing row selects where the selected path source is sent to as a destination.
•
The Buses row selects the various Main, Group Auxiliary and Track bus which may or may not be have been assigned to a fader
on the surface, for the purpose of controlling the output level of the chosen bus.
•
The Monitoring row selects the required monitoring output, controls its level, cut and dim settings and selects which signal path
will be monitored based on the width of the monitoring system.
PROCESSING MODE ROW
BUSES MODE ROW
The image below shows the Wild Assign
Processing>Input
panel in
mode.
The layout of the controls approximately
mimics the layout of the TFT touchscreen
and changes according to the type of path
and the mode that has been selected.
CA6575 WILD ASSIGN PANEL DETAIL
36 ImPulse
IP Audio Routing & Mixing System
ROUTING MODE ROW
MONITORING MODE ROW
Here we are looking at the Input controls
for a stereo path on Fader 2A which are
laid out across the top 3 rows of the
panel, which provides up to 36 rotary and
button controls cells with an associated
TFT display for each parameter displayed.
The bottom row of 12 control cells are
used here to display individual Input gain
or Input trim levels of each fader strip
where valid. This row of controls can
be custom defined to display whatever
control is required to be at hand from
Show setup>Customise panels.
Start Up Guide
Advertisement
Table of Contents
