Table of Contents
Advertisement
12. EXAMINE AN EXAMPLE SYSTEM (SURFACE+CORES+DEVICES)
This example system is a 36 fader Argo S console surface, connected to a pair of Impulse cores using interface #3 shown in
Blue
for
Red
Primary and
for Secondary redundancy connections. The Impulse cores are connected to each other using Interface #5 shown
Green
in
to provide a redundant link. There are 2 PTPv2 aware audio switches providing audio redundancy. Each switch has its own
VLAN setup (Primary=VLAN30 and Secondary=VLAN31) for AoIP interfacing. All Primary AoIP traffic is on the 192.168.30/24
subnet and all Secondary AoIP traffic is on the 192.168.31/24 subnet. There are 3 Modular I/O Racks with AoIP interfaces and
in the case of Modular I/O rack 1, both AoIP Device interfaces have been used as the I/O count exceeds the nominal 256 limit per
connection. The Modular I/O Racks are connected to the single Router fitted in each core via the switches. All the required A ports
of each Router (primary & secondary cores) and Modular I/O rack AoIP Device interfaces are connected to the Primary audio switch
and all the required B ports of each Router (primary & secondary cores) and Modular I/O rack AoIP Device interfaces are connected
to the Secondary audio switch. The Connect Application can be accessed from interface #2 of the Primary core on 172.16.255.60
or when the Management subnet is configured from 172.29.1.21 or the Primary switch on 192.168.30.100 for setup via the PC.
32 ImPulse
Start Up Guide
IP Audio Routing & Mixing System
Advertisement
Table of Contents
