Calrec Argo S Startup Manual page 19

AoIP I/O Core and Device Interfaces
This page is accessed from the Devices
Menu and appears as shown above right.
Here we are showing two items:-
'calrec-system' which is the chosen
name for the Impulse core & 'Combo 31',
which is a Type R Combo AoIP device.
The interface information for 'Combo 31'
is shown middle right.
Each row on the interface sub-page table
represents an AoIP interface connection,
on a Type R AoIP device there is 1 set of
AoIP interfaces having both a Primary and
Secondary connection.
The columns in the table provide
information about:-
- AoIP interface's status:- Green is active,
Red is not active.
- AoIP interface name.
- AoIP interface IP address.
- Type of IP address, i.e. if the IP address
type is static (manually configured) or
DHCP (dynamically allocated).
- AoIP interface's MAC address.
- AoIP interface connection speed.
- AoIP interface TX use percentage.
- AoIP interface RX use percentage.
Configure IP Settings for IO Boxes
Clicking on any of the AoIP interface
rows on the Core or AoIP devices, opens
a dialogue box. The IP settings for the
selected AoIP interface are shown below
right for the AoIP 1: Pri interface for
'Combo 31'.
The user sets up the IP address by
modifying the following 4 fields:-
Mode:- Type of IP address, i.e. if the
IP address type is a static manually
configured address or if it is a DHCP
dynamically allocated address.
IP Address:- This example shows that the
device & router are in the same subnet.
Subnet Mask:- Typically set to
255.255.255.0 or /24.
Gateway:- Optional.
CONNECT>DEVICES>AOIP CORE INTERFACES
CONNECT>DEVICES >AOIP I/O DEVICE INTERFACES
CONNECT>DEVICES>AOIP I/O DEVICE INTERFACES-EDIT IP ADDRESS
19