Calrec Argo S Startup Manual page 22

Patch Receiver Streams to AoIP
Device Physical Outputs
Now the receivers for the AoIP Devices
are setup, the next step is to patch those
to the physical output ports in the AoIP
device.
Audio Outputs configuration
This page is accessed from the Devices
menu when an AoIP Device's 'Audio
Outputs' tab is selected and appears as
shown above right.
The page shows 3 receiver streams down
the left side which can be folded open
+ or closed- to make the streams easier
to manage. The Line Out Stream is
expanded to show the stream channels.
Along the top are shown the physical
Output ports available in the device and
the user simply clicks on the crosspoint
between the receiver stream channels
and output ports to patch them together.
------------------------------------------------------------------------------------------------------------------------------------------------------------
Analogue level Options
Clicking on the 3 dots icon in the top right
corner of the page opens a drop down
shown below right, which allows the user
to perform various functions. From an
analogue point of view there are two of
these of interest, the first being the ability
to set the analogue level representing
0dBFS and the second of these is to set
the 'Mic input headroom'.
On selecting the 'Analogue level at
0dBFS' option a drop down appears as
shown below at the bottom centre of
this page.
The user selects the operating level
required. The Calrec default for this is
0dBFS=18dBu.
On selecting the 'Mic Input Headroom'
option a drop down appears as shown
below at the bottom right of this page.
The user selects the operating
headroom required. The Calrec default for
this is 28dB.
22 ImPulse
IP Audio Routing & Mixing System
CONNECT>DEVICES >RECEIVER STREAMS TO AUDIO OUTPUTS
Label Selection
The user can click on the existing label
and a label entry box appears. The user
edits the label as required and clicks on
'Apply'.
CONNECT>DEVICES >OPTIONS>ANALOGUE LEVEL OPTIONS FOR AUDIO
ANALOGUE LEVEL @ 0DBFS
Lock Selection
The user can click on the padlock symbol,
this will prevents any parameter changes
from being made and will appear as a
yellow padlock when active.
MIC INPUT HEADROOM
Start Up Guide