Table of Contents
Advertisement
Setup AoIP Device Transmitters
and AoIP Core Receivers for Inputs
configuration
Now the AoIP Core Router & AoIP Device
interfaces are setup, the next step is to
create transmitter and receiver streams
for them using the 'Connect' application.
AoIP Device Transmitters
The user configures AoIP transmitters in
the device, the page shown above right is
accessed from the Devices menu when
the 'Combo 31' device's 'Transmitters' tab
is selected, it is used to add/remove and
configure transmitters.
The number of transmitters shown here
for a Type-R AoIP device is 8, this is
based on there being 1 AoIP interface
Primary/Secondary set, each of which
carries 64 channels with each stream
carrying 8 channels, thus providing
64/8=8 available transmitters.
Each row on the transmitters sub-page
table represents a transmitter.
The columns in the table provide the
following information about:-
- Transmitter name e.g. Mic In.
- Transmitter interface e.g. AoIP 1:Pri.
- Type of transmitter, normally defined as
a Multicast one to many type rather that
a Unicast one to one type.
- Number of channels in each transmitter
e.g. 8.
- Codec used e.g. L24.
- Packet time e.g. 125us.
-Sample Rate e.g. 48000Hz.
Transmitter Settings - Device
When the user selects one of the
available transmitters or clicks on 'Add
Transmitter' at the bottom of the page, a
dialogue box appears allowing the user to
configure the transmitter as shown below
right.
VIEWING ONLY
It shows information for
and also settings that can be ADJUSTED.
24 ImPulse
IP Audio Routing & Mixing System
CONNECT>DEVICES>AOIP I/O DEVICE TRANSMITTERS
CONNECT>DEVICES>AOIP I/O DEVICE TRANSMITTERS- ADD/EDIT/DELETE
Source Device:
This is set on the
summary page using 'Connect'.
Transmitter Name: The user can edit
the transmitter name by clicking in the
Name field and saving it.
No of Channels in the Transmitter:
The maximum number of channels that
can exist in a stream is 80, however a
channel count of either 8 or 16 channels
is more common for passing groups of
related channels to a destination.
Refer to the Connect Application
Guide (926-292).pdf for further
information beyond this simple setup of a
transmitter, including Advanced Settings.
Start Up Guide
Advertisement
Table of Contents
