Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging - Hitachi RB18DSLP4 Safety Instructions And Instruction Manual

English

ASSEMBLY AND OPERATION

APPLICATIONS

Cleaning house etc.
Blowing operation.
REMOVAL AND INSTALLATION
METHOD OF BATTERY
How to install the battery.
Align the battery with the groove in blower
handle and slip it into place.
Always insert it all the way until it locks in
place with a little click, If not, it may
accidentally fall out of the blower, causing
injury to you or someone around you (Fig. 2).
How to remove the battery.
Withdraw battery from the blower handle
while pressing the latch (2 pcs) of the battery
(Fig. 2).
Battery
(Optional accessory)

CHARGING

For rechargeable batteries, please charge in
according to the handling instructions of the
charger which you are using.

BEFORE USE

Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure
that lighting and ventilation is adequate.
10
Handle
Latch
Push
Pull out
Insert
Fig. 2
MOUNTING AND DISMOUNTING THE
NOZZLE
Mounting the NozzIe
Insert the pin located outside the nozzle into
the notch provided on the blast port, and fully
turn the nozzle in the direction indicated by
the arrow in Fig. 3.
To dismount the nozzle.,folIow the above
procedures in reverse.
Pin
Nozzle
Blast port
HOW TO USE THE CORDLESS
BLOWER
Switch operation
When the trigger switch is depressed, the
blower rotates. When the trigger is released,
the blower stops.
Notch
Fig. 3