LAUNCH TECH X-431 PRO3 SE User Manual page 76

LAUNCH
the security password (If it is an open network, password is not required), and
then tap Confirm.
3. Once the Wi-Fi network of the printer is connected and the printer is found,
tap Printing test to test the printing.
Now the Wi-Fi printer is ready for printing.
If the printer is not found, please reset the printer to default factory settings (refer
to Step 2 for details) and check whether the current device and the printer are on
the same LAN.
B. If you have configured the Wi-Fi printer to the LAN:
2. Tap Connect to Printer:
a). If the local network remains as it is, tap Test Print directly to test the
printing.
b). If the local network changes, you have to reset the Wi-Fi printer.
For other Wi-Fi printers,
Before printing, make sure the following conditions are met:
• The Wi-Fi printer is powered on and working normally.
• The print service plug-in associated with the printer is already installed on the
tablet (Go to Google Play or use the Browser to download and install it).
Follow the steps below to proceed:
1. Set the default printer as System.
2. Go to Other Modules -> Tablet Settings -> WLAN, set the WLAN switch to
Off.
3. On the report details page, tap
X-431 PRO3 SE User Manual
.
68