Table of Contents
Advertisement
6
INSTALLATION
Preparation of location and
electrical installation for the oven
is the customer's responsibility.
The appliance should be properly
installed and grounded by a qualified
technician. The appliance must
be installed in accordance with all
local electrical regulations. Prior
to installation, visually inspect the
appliance for any defects. Do not
install a defective appliance.
6.1
ELECTRICAL
REQUIREMENTS
This appliance must be supplied with
the proper voltage and frequency
and be connected to an individual,
properly grounded branch circuit
protected by a circuit breaker or fuse.
See the rating plate to
rating of the appliance. Use the chart
below to determine the minimum
recommended dedicated circuit
protection to ensure correct fuse
rating.
kW
Rating 240
V
<8.8 kW
The main supply data must
correspond to the data specified on
the rating plate of the appliance. The
rating plate is located either bottom
of the control panel when opening
the door or on the rear wall of the
appliance.
determine the
Recommended
Circuit Size
(Dedicated)
40 Amp
WARNING
To avoid risk of electrical
shock, serious injury, or
death, verify electrical
power is turned off at the
breaker box until oven
is installed and ready to
operate.
ELECTRICAL SHOCK
HAZARD! DO NOT
USE AN ADAPTER
PLUG, AN EXTENSION
CORD, OR REMOVE
GROUNDING PRONG
FROM ELECTRICAL
POWER CORD ,
HAVE A QUALIFIED
ELECTRICIAN INSTALL
AN OUTLET NEAR THE
APPLIANCE. FAILURE
TO FOLLOW THIS
WARNING CAN CAUSE
SERIOUS INJURY, FIRE
OR DEATH.
This appliance is manufactured with
a green GROUND wire connected
to the oven chassis. Ensure power
is disconnected or turned off at the
main supply before making any
electrical connections. Connect
the flexible conduit to the junction
box using a U.L. listed conduit
connector. The following procedures
present the most common ways of
13
DANGER
Advertisement
Table of Contents
