Wireless Authentication Tab - Setting The Wireless Authentication - Sony IPELA SNC-RZ25N User Manual

Domain suffix
Type the wireless network domain suffix of the camera
to be transmitted to the DHCP server. This setting is
valid only when Obtain an IP address automatically
(DHCP) is selected in the Wireless tab.
Note
The domain suffix is sent to the DHCP server as FQDN
(Fully Qualified Domain Suffix) information when Host
name is set.
Type
Select the network connection type Ad hoc mode or
Infrastructure mode. Select Ad hoc mode when
connecting to the computer directly, or select
Infrastructure mode when connecting to the computer
via an access point or a radio router. When you select Ad
hoc mode, specify the wireless channel.
Note
The setting of the HTTP port number is common to the
setting of the network cable.
Antenna
When you use dedicated wireless card SNCA-CFW1,
you can select one of the following antenna settings.
Internal: Suitable for short-range sending and
receiving because it is non-directional. Select it when
you use the camera inside.
External: Attaching an external antenna to SNCA-
CFW1 will enable long-range sending and receiving.
Select it when you need long-range sending and
receiving with attached external antenna.
Diversity: Uses either the inside or external antenna
which has higher sensitivity. In this case, the
sensitivity is slightly lower than the settings Internal
and External.
OK/Cancel
See "Buttons common to every setting menu" on page
31.
44
Configuring the Network — Network setting Menu
Wireless authentication Tab —
Setting the Wireless Authentication
Set the authentication necessary for the wireless
connection.
SSID
Type the ID to identify the wireless network you want to
access using up to 32 ASCII characters (alphanumeric).
For your security, be sure to change the factory setting.
WEP
Select On when you use the WEP (Wired Equivalent
Privacy) keys, or Off when you do not use it.
The WEP key data settings are valid only when the WEP
menu is set to On.
WEP key data
Specify up to 4 WEP keys. The length of a WEP key is
40 or 104 bit. A 104-bit WEP key has a higher security
level than a 40-bit key. You can type the WEP key either
in hexadecimal numbers (0 to 9 and A to F) or ASCII
characters (alphanumeric).
When the Type menu is set to Infrastructure mode, the
WEP key should be the same as that of the access point.
When the Type menu is set to Ad hoc mode, the WEP
key should be the same as that of the communication
client.
Notes
• When you remove the wireless LAN card, be sure to
first turn off the power of the camera.
• When you use a wireless LAN card, the throughput of
communication data through the Ethernet may
decrease.
OK/Cancel
See "Buttons common to every setting menu" on page
31.