Table of Contents
Advertisement
Note
When you have set the HTTP port number to a number
other than 80 in the Network menu or in the IP Setup
Program, access the camera again by typing the IP
address of the camera on your Web browser as follows:
Example: when the HTTP port number is set to 8000
OK/Cancel
See "Buttons common to every menu" on page 31.
—
Wireless Tab
Setting of wireless
connection
Insert the specified wireless card into the PC card slot of
the camera, and set the items for connecting to the
wireless network.
Before setting, read the operation manual and
installation manual supplied with the wireless card
together with this guide.
Verified wireless cards
• Optional Sony Wireless Card SNCA-CFW1 and
SNCA-CFW5*
• A commercially available CompactFlash type II-
PCMCIA adapter
* SNCA-CFW5 is not available in some countries and
areas. For details, contact your authorized Sony
dealer.
Notes
• Before removing the wireless card from the camera,
turn off the power of the camera.
• The throughput of the data transmission/reception via
the network cable may decrease when the wireless
card is in use.
MAC address
Displays the MAC address of the wireless card inserted
to the PC card slot.
If a wireless card is not inserted, "00:00:00:00:00:00" is
displayed.
IP address
Configure the IP address for a wireless network.
Obtain an IP address automatically (DHCP): Select
this option when a DHCP server is installed on the
network to allow IP address assignment. With this
setting, the IP address is assigned automatically.
Use the following IP address: Select this option when
you set a fixed IP address. With this setting, specify
the IP address, Subnet mask and Default gateway
manually.
Note
When you select Obtain an IP address automatically
(DHCP), make sure that a DHCP server is operating on
the network.
IP address
Type the IP address of the camera.
Subnet mask
Type the subnet mask.
Configuring the Network — Network Menu
45
Advertisement
Table of Contents
