Wireless Tab - Setting Of Wireless Connection - Sony IPELA SNC-RZ25N User Manual

Setup Program, access the camera again by typing the IP
address of the camera on your Web browser as follows:
Example: when HTTP port number is set to 8000
OK/Cancel
See "Buttons common to every setting menu" on page
31.
Wireless Tab — Setting of Wireless
Connection
Insert the specified wireless LAN card into the CF card
slot of the camera, and set the matters to connect to the
wireless network.
Use the optional wirless LAN card SNCA-CFW1 for the
wireless connection.
Note
If you use the wireless function of this unit, set a
network address defined by the IP address, subnet mask
and default gateway in the Wireless tab. In this case, the
network address should be different from the priority
connection set in the Network tab.
MAC address
Displays MAC address of the wireless LAN card
inserted to the CF card slot.
If any wireless LAN card is not inserted,
"00:00:00:00:00:00" is displayed.
Obtain an IP address automatically
(DHCP)
DHCP server is installed on the network. Select it when
the IP address is assigned by DHCP server. IP address is
assigned automatically.
Note
When you set Obtain an IP address automatically
(DHCP), make sure that DHCP server is working on the
internet.
Use the following IP address
Select this when a fixed IP address is set.
IP address
Type the IP address of the camera.
Subnet mask
Type the subnet mask.
Default gateway
Type the default gateway.
Obtain DNS server address automatically
Select this to obtain the address of DNS server
automatically. It can be set only when Obtain an IP
address automatically (DHCP) is selected.
Note
When you select "Obtain DNS server address
automatically", make sure that DHCP server is active on
the network.
Use the following DNS server address
Select this when you set the fixed address as the IP
address of DNS server.
Primary DNS server
Type the IP address of the primary DNS server.
Secondary DNS server
Type the IP address of the secondary DNS server, if
necessary.
Host name
Type the wireless network host name of the camera to be
transmitted to the DHCP server. This setting is valid
only when Obtain an IP address automatically
(DHCP) is selected in the Wireless tab.
Configuring the Network — Network setting Menu
43