Sending An Image Via Mail - E-Mail (Smtp) Setting Menu; Common Tab - Setting The E-Mail (Smtp) Function - Sony IPELA SNC-RZ25N User Manual

Sending an Image via
mail
— e-Mail (SMTP) setting
Menu
When you click e-Mail (SMTP) on the Administrator
menu, the e-Mail (SMTP) setting menu appears.
By using e-Mail (SMTP) function, you can send a mail
with attached image file which has been shot linked with
the external sensor input or with the built-in motion
detection function. The image file can also be sent
periodically.
e-Mail (SMTP) setting menu is composed of three tabs:
Common, Alarm sending and Periodical sending.
Common Tab — Setting the e-Mail
(SMTP) Function
e-Mail (SMTP)
Select On when you use the e-Mail (SMTP) function.
The common setting options are displayed below.
If you do not wish to use the e-Mail (SMTP) function,
select Off and click OK.
Note
During transmission of an image file via mail, the frame
rate and operation performance of the monitor image of
the main viewer decline.
SMTP server name
Type the SMTP server name up to 64 characters, or the
IP address of the SMTP server.
Authentication
Select the authentication required when you send an e-
Mail.
Off: Select if no authentication is required when an e-
Mail is sent.
On: When authentication is required an e-Mail is sent,
select one of the authentication methods from the
followings.
SMTP: Select if authentication is required when an
e-Mail is sent.
POP before SMTP: Select if POP before SMTP
authentication is required when an e-Mail is sent.
Note
When you set to On, be sure to select either or both
SMTP or/and POP before SMTP.
POP server name
It is necessary when the POP before SMTP is selected
in Authentication.
Type the POP (receiving mail) server name up to 64
characters, or type the IP address of the POP server. This
setting is necessary when the SMTP server which sends
e-mails performs authentication using the POP user
account.
User name, Password
Type the user name and Password of the user who has
the mail account. This setting is necessary when the
SMTP server which sends e-mails performs
authentication.
Recipient e-Mail address
Type the recipient e-Mail address up to 64 characters.
You can specify up to three recipient e-Mail addresses.
Administrator e-Mail address
Type the Administrator e-Mail address up to 64
characters.
This address is used for reply mail and sending system
messages from the SMTP server.
Subject
Type the subject/title of the e-Mail up to 64 characters.
When Alarm sending of the alarm tab is set to ON, the
mail sent due to the alarm detection will indicate the
type of alarm in the subject. [S1] is added for sensor
input1 detection, [S2] is added for sensor input2
detection, and [MD] is added for motion detection.
Message
Type the text of the e-Mail up to 384 characters. (A line
break is equivalent to 2 characters.)
OK/Cancel
See "Buttons common to every setting menu" on page
31.
Sending an Image via mail — e-Mail (SMTP) setting Menu
49