Pppoe Tab - Setting Of Pppoe Connection - Sony IPELA SNC-CS10 User Manual

Default gateway
Type the default gateway.
Obtain DNS server address automatically
Select this to obtain the address of DNS server
automatically. It can be set only when Obtain an IP
address automatically (DHCP) is selected in the
Network tab.
Note
When you select "Obtain DNS server address
automatically", make sure that DHCP server is active on
the network.
Use the following DNS server address
Select this when you set the fixed address as the IP
address of DNS server.
Primary DNS server
Type the IP address of the primary DNS server.
Secondary DNS server
Type the IP address of the secondary DNS server, if
necessary.
Host name
Type the host name of the camera to be transmitted to the
DHCP server. This setting is valid only when Obtain an
IP address automatically (DHCP) is selected in the
Network tab.
Domain suffix
Type the domain suffix of the camera to be transmitted
to the DHCP server. This setting is valid only when
Obtain an IP address automatically (DHCP) is
selected in the Network tab.
Note
The domain suffix is sent to the DHCP server as FQDN
(Fully Qualified Domain Suffix) information when Host
name is set.
HTTP port number
Normally select 80. If you want to use a port number
other than 80, select the text box and type a port number
between 1024 and 65535.
Note
When you have set the HTTP port number to a number
other than 80 in the Network menu or in the IP Setup
Program, access the camera again by typing the IP
address of the camera on your Web browser as follows:
38
Configuring the Network — Network Menu
Example: when HTTP port number is set to 8000
OK/Cancel
See "Buttons common to every menu" on page 28.
PPPoE Tab - Setting of PPPoE
Connection
Use it when you connect the camera with PPPoE (Point-
to-Point Protocol over Ethernet). PPPoE connection is
the protocol that is widely used in xDSL (digital affiliate
line such as ADSL, VDSL or SDSL) as the
authentication and connection system.
PPPoE
Set whether you connect the camera using PPPoE
function or not. When On is selected, PPPoE connection
is used.
IP address
When you connect to the network by PPPoE function, IP
address obtained at PPPoE connection is displayed.
User ID
Type the user ID for the authentication necessary for
PPPoE connection. Type up to 64 characters.
Password
Type the password for the authentication necessary for
PPPoE connection. Type comfirm from 1 to 32
characters.