Safety Information; Important Safety Instructions - Life Smart Willow Owner's Manual

IMPORTANT SAFETY
INSTRUCTIONS
READ AND FOLLOW ALL
INSTRUCTIONS
AVOIDING THE RISK TO CHILDREN
DANGER:
• RISK OF CHILD DROWNING: Extreme
caution must be exercised to prevent
unauthorized access by children. To avoid
accidents, ensure that children cannot use
a spa unless they are supervised at all
times. Children should be supervised to
not use the spa as a toy.
WARNING:
• To reduce the risk of injury, do not permit
children to use this product unless they
are closely supervised at all times.
• To reduce the risk of injury, lower water
temperatures are recommended for young
children. Children are especially sensitive
to hot water.
DO:
• Make sure you always lock the child
resistant locks after using the spa for your
children's safety. Every spa is equipped
with a locking cover that meets the ASTM
F1346-91 Standard for Safety Covers.
• Test the water temperature with your hand
before allowing your child to enter the spa
to be sure that it's comfortable. Children
are especially sensitive to hot water.
• Remind children that wet surfaces can be
very slippery. Make sure that the children
are careful when entering or exiting the
spa.
DON'T:
• Allow children to climb onto the spa cover.
• Allow children to have unsupervised
access to the spa.

SAFETY INFORMATION

1
AVOIDING THE RISK OF
ELECTROCUTION
RISK OF ELECTROCUTION:
• Connect only to a grounded source.
• Do not bury the power cord. A buried
power cord may result in death or serious
personal injury due to electrocution if direct
burial-type cable is not used, or if improper
digging occurs.
• A ground terminal (pressure wire
connector) is provided on the control
box inside the unit to permit connection
of a minimum No. 10 AWG solid copper
bonding conductor between this point and
any metal equipment, metal water pipe,
metal enclosures of electrical equipment,
or conduit within 5 feet (1.5 m) of the
unit as needed to comply with local
requirements.
WARNING:
• Your spa must use a Ground Fault
Circuit Interrupter for user and equipment
protection. To ensure proper operation of
this important safety device, test according
to the following instructions per electrical
configuration.
115 VOLT, CORD-CONNECTED
MODELS:
• The GFCI is located at the end of the
power cord. Before each use, with the
unit operating, push the TEST button.
The unit should stop operating and the
GFCI power indicator will go out. Wait
30 seconds and then reset the GFCI by
pushing the RESET button. The GFCI
power indicator will turn on, restoring
power to the spa. If the interrupter does
not perform in this manner, there may
be an electrical malfunction and with
it, the possibility of an electric shock.
Disconnect the power until the problem
has been corrected.
NOTE: This will reset the filter cycle.