Fill-Up And Start-Up Instructions; Filling The Spa With Water; Applying Power - Life Smart Willow Owner's Manual

FILL-UP AND START-UP INSTRUCTIONS

The following procedures should be followed
on initial startup and whenever the spa is
drained for routine maintenance.
FILLING THE SPA WITH
WATER
1. Clear all the debris from your spa.
2. Be sure to open all jets to allow as much
air as possible to escape from the plumb-
ing during the filling process.
3. Insert a garden hose into filter
compartment to fill your spa.
NOTE: Do not use hot or softened water.
4. As the water level rises, check inside the
equipment compartment for water leaks. It
may be necessary to tighten unions
EQUIPMENT COMPARTMENT
and/or fittings that may have loosened
during delivery. There is no need to call
for service; this can easily be done.
If assistance is required, contact a
Customer Service representative at (888)
961-7727 Ext. 8440.
5. Under normal circumstances keep the
water level half way between the top of
the spa and the top of the filter ring or
just above the highest jets (whichever is
higher).
Failure to keep enough water in your spa
may result in damage to your system and
invalidate your warranty. If your spa filter is
sucking in air causing the pump to cavitate,
you need to add water!
6. Check the filter installation and make sure
the filter is not loose.

APPLYING POWER

1. Turn power to spa "ON" (after filling spa)
from the main panel at the house and the
subpanel.
2. Press Jets button on the topside control
panel to activate the spa. Rotate all the
air control valves clockwise and observe
the increased jet action (air mixed with
water). After several minutes.
3. While the pump is running
UNIONS
check again for water leaks at the
drain spigot, unions, or fittings in
the equipment compartment (leaks
may have occurred during transit).
If water is leaking from one of these
areas, there is no need to call for
service. Simply tighten the fitting.
If assistance is required, call a
Customer Service representative at
(888) 961-7727 Ext. 8440.
4. After checking your spa for
leaks it is now time to adjust your
spa settings. Press the Plus or
Minus button on your topside
control panel until the display
indicates your desired temperature is
set, after 5 seconds of non activity the
control panel will display the actual water
temperature.
17