Component Operation; Spa Component Operation - Life Smart Willow Owner's Manual

SPA COMPONENT
OPERATION
AIR CONTROL VALVE
The air control valves (smaller valves) serve
to regulate the amount of air mixed with the
water when the jets are operational. Turn
the air control valves in one direction to
increased jet action. Rotating the air control
in the opposite direction to turn air off and
allow the jets to work with water only. Turn
the air controls off when the spa is not in use,
this will prevent cold air from entering the spa
and will keep heating cost to a minimum. The
ozone jet, will always produce air bubbles
when pump is on.
DIVERTER VALVE
(Willow/LSA-510L model only)
The diverter valves (larger valves) on your
spa allows you to direct the flow of water to
one of the jet flow combinations. Your spa
has two pumps and two diverter valve, each
diverter valve works with one pump. The
function of the diverter valves can best be
learned by experimentation. Turn the large
valve completely to one side to see which jets
are on, then turn completely to the other to
see which jets are affected if nothing seems
to happen than try the other diverter valve.
(You can adjust the diverter value to any
position between the two possible extremes
to achieve the jet pressure that feels best to
you.)
IMPORTANT: Your spa is not designed to
provide full power to all jets when the diverter
valves are in the "mid" position. However with
the diverter valve in this position, you may
increase the power to selected jets by rotating
the faces of the hydrotherapy jets to close the
ones that are not in use.

COMPONENT OPERATION

16
HYDROTHERAPY JETS
The hydrotherapy jets are recessed in the
wall of the spa. Rotate the large or medium
jet faces to turn the jets on or off. Turning a
jet on or off will increase or decrease the ef-
fects of any jets not in the closed position.
OZONE GENERATOR
The ozone system enhances the quality of
the spa water when used to supplement
the spa owner's regular water maintenance
program. Contrary to some information
circulated throughout the pool and spa
industry regarding ozone systems, ozone
CAN'T be used as a single-source sanitizer,
water clarifier, anti-foamer, and mineral
chelating agent. A secondary source sanitizer
must be used to maintain
3.0 - 5.0 ppm of Free Available Chlorine
(FAC). LIFESMART recommends that a
chemical maintenance program based
on recognized and documented industry
standards still be followed when using an
ozone purification system to assure water
sanitation and the highest quality purified
water.
WATERFALL
(When Equipped)
Your spa has a control valve to operate the
amount of flow through the waterfall from no
flow to a steady stream. This valve is near the
waterfall. The waterfall will only work when
Jet Pump 1 is on. Rotate the valve to turn on
or off.