Control Panel Operation; Display Overview; Jets Operation; Multi Color Led Light - Life Smart Willow Owner's Manual

INITIAL START-UP -
is first powered up the spa panel display
(view right) will go through a specific
sequence. This sequence is normal
and will display a variety of information
regarding the configuration of the control
system. After the sequence ends, the
control system will start Priming Mode
which will last for 4-5 minutes.
During Priming Mode this panel message
(view right) indicates that
the spa is in Priming Mode,
the heater is disabled to
allow the priming process
to be completed without the
possibility of energizing the
heater under low-water-flow
or no-water-flow conditions.
When Priming Mode ends
the panel will display dashes. Once the
control system cycles water through the
heater for one minute, the dashes will be
replaced by the water temperature.
Your spa has been designed so that it will
automatically heat the water to the factory
set temperature of 100°F (38°C) unless you
set the spa to a different temperature. If
power is disconnected from the spa, it will
automatically revert back to the last saved
set temperature when power is reapplied.
NOTE: The Palmetto LSA-720 & LSA-720L
have two pumps using the 2 pump Control
Panel.

JETS OPERATION

Jet Pump 1 button:
• Press Jets 1 button once to turn Jet Pump
1 on low speed.
• Press Jets 1 button a second time to turn
Jet pump1 on high speed.
• Press Jets 1 button a third time to shut Jet
Pump1 off.

CONTROL PANEL OPERATION

When the spa
I Pump Control Panel
Spa Panel Display
2 Pump Control Panel
NOTE: When the low-speed turns on
automatically due to spa temperature
detection (polling) and then to heat to the set
temperature if needed, it cannot be turned off
from the panel, however the high speed may
be started.
Jet Pump 2 button:
(Available on Palmetto NL LSA-720 &
Palmetto L LSA-720L models only)
• Press Jets 2 button once to turn Jet Pump
2 On.
• Press Jets 2 button a second time to shut
Jet Pump 2 Off.

MULTI COLOR LED LIGHT

Press the Light button once to turn on the
lights, press the button again to turn the
lights off, when turning back on after several
seconds the same light mode will appear.
Every time the light is quickly turned off
and on a new light mode will appear. The
sequence is as follows:
White, Aqua, Magenta, Azure, Amber,
Emerald, Ruby, Color wheel with abrupt color
changes, Slow full color wheel and Fast full
color wheel.
NOTE: If left on, the light will automatically
turn off after 4 hours of operation.
11