Temperature Adjustment - Life Smart Willow Owner's Manual

TEMP ADJUSTMENTS
The current water temperature will constantly
display on LCD.
Press the Warm/Temp ʌ or Cool/
Temp V buttons to display the set
temperature (desired temperature).
Each time either button is pressed
again, the set temperature will
increase or decrease depending on
which button is pressed.
After five seconds, the LCD will automatically
display the current spa temperature.
TEMPERATURE RANGE
The temperature can function between
80°F - 104°F (26.6°C - 40°C) High Range
(TR:HI) or 50°F - 99°F (10°C - 37.2°C)
Low Range (TR:LO).
To change the Temperature Range between
Hi and Low do the following:
• Press the TEMP button.
• While set TEMP is Flashing,
press LIGHT button until
TR:HI or TR:LO appears. The
first one to appear is the current
range.
• To change, press the TEMP
button followed by the LIGHT
button to save new setting.
IMPORTANT: IF YOUR SPA SET RANGE
WILL NOT GO HIGHER THAN 99°F (37.2°C)
YOU ARE IN THE TR:LO MODE! CHANGE TO
TR:HI MODE FOR A HIGHER TEMPERATURE
SEQUENCE KEY
Flashing characters
Progressive message
Press TEMP button for "action"
Press LIGHT button to "select"
Pause / back to Main Screen / setting not saved
Pause / back to Main Screen / setting saved
Menu Items may or may not appear
CONTROL PANEL OPERATION
HEAT MODES
There are two heat modes you can select
from, the Ready Mode (RDY) and Rest Mode
(REST).
• Ready Mode keeps the water temperature
close to the Set Temperature 24 hours a
day. Use this mode for everyday usage.
• Rest Mode only heats water during filter
cycles. Use this mode if spa is not used
for extended periods of time.
To change the Heat Modes do the following:
• Press the TEMP button.
• While set TEMP is Flashing,
press LIGHT button two times
until RDY or REST appears.
The first one to appear is the
current Heat Mode.
• To change to the other mode
press the TEMP button
followed by the LIGHT button.
When in the Rest Mode the main
screen will alternate between water
temperature and REST.
NOTE: A third mode will activate
and display (RRST) whenever the JETS
button is pressed while in the REST mode
this is called Ready-in-Rest mode and will
run for 1 hour. This subfeature mode will
turn the heater on and attempt to keep the
water temperature close to the
set temperature. The main screen
will alternate between water
temperature and RRST for the hour.
12