Table of Contents
Advertisement
Install Front Baffle
1.
Locate baffle inside front of mower with formed
notch to the right side. Bend baffle to conform to
mower front radius and even with lower edges of
outer cutting chambers. Clamp baffle at the
center.
2.
Drill a 9 mm hole through the front of the
mower next to clamp at center. Secure baffle to
mower at center with 5/16–18 x 3/4" (19mm)
bolt, through from the inside, and a thin 5/16
lock nut (Fig. 2).
Note:
Use the holes in the baffle only as a
guide for hole location. It is not
necessary to use there exact location.
Note:
Look, before drilling holes, that there
will be clearance for installing bolts.
3.
Working left and right from the center, drill (4)
9 mm holes in mower. Secure baffle with
5/16–18 x 3/4" (19mm) bolts, through from the
inside, and secure with thin 5/16 lock nuts
(Fig. 2).
3
2
Figure 2
1. 37" mower
2. Front baffle
3. Drill 9 mm hole at center
4
5
2039
4. Bolt 5/16–18 x 3/4"
(19mm)
5. Lock nut 5/16' thin
Install Belt Guard Hold-Down
1.
Remove existing bolt securing kicker at center
rear of mower. Replace with longer 5/16–18 x
1-1/4 (32 mm) bolt from kit. Insert from inside
mower and secure with 5/16 nut (Fig. 3).
2.
Position hold–down over bolt at the rear and to
the right of the step on belt guard (Fig. 3).
Secure hold-down with 5/16 thin lock nut
(Fig. 3).
1. Belt cover
2. Bolt 5/16–18 x 1-1/4"
(32 mm)
1
1
2
Figure 3
3. Nut 5/16"
4. Hold–down bracket
5. Lock nut 5/16" thin
Installation
5
4
3
2040
5
Advertisement
Table of Contents
